The necessity of brick-faced bracing, the role of bracing is to accept surface, local expansion and contraction and distribute it uniformly in the facade of the building. In addition, the strapping should prevent the entry of water and humidity into the inner layers of the walls and other parts of the building. Therefore, the mortar must be fine-grained and full of substance to prevent hair attraction. As the final work, stringing should complete the attractiveness of the landscape.

The width of the bricks is 8 to 20 mm based on the chosen design, and the place of its execution must be cleaned with a brush and moistened and sprayed before starting the work. The minimum grade of cement is 400 kg of cement per cubic meter, the diameter of the aggregate should not be more than 1 mm. You can buy all kinds of bricks to the site Kasri Marshipur refer to

What is a brick facade?

The necessity of tying the brick facade, in brick facades, after the completion of the porcelain brick, in order for the facade of the building to look uniform and coherent, it must be Let’s cover all the grooves in the middle of the facades with straps. Some facades are double-braced, that is, there are straps only in the longitudinal parts, and others are made with four straps. The drawstring allows for expansion and contraction superficial and local and its distribution as at once It is the view of the building.

In addition to The drawstring should prevent the penetration of water and moisture To layers Inside the walls and other parts The building became round. Hence, the mortar It should be small It was creamy and dense It should be enough to prevent you from creating something special Hair attractionto be

Stringing as a job Finally, the attractiveness of the view should be complete reach the end.the depth Strapping for brick facades equal to 15 It is a millimeter that should be the place of its implementation with Clean wire brush before starting workMoist and splash water.

Important note: You can buy Plaque facade brick Refer to the products page.

Tips on how to tie:

• Before installing the bricks, the joint of the brick on the wall must be moistened.
• The minimum and maximum mortar thickness behind the brick should be between 2 and 4 cm
• The best temperature for installation is between 5 and 35 degrees Celsius, and facade work should never be done during frost.
• The sand and water used in mortars must be free of any organic matter.
• If the banding is raised, you should be careful not to create a groove when shaping it, because the water will remain inside the groove and after some time it will absorb moisture into it. Thicker strapping is actually the best type because of the low internal curvature Brick strapping is.
• The most suitable time for stringing is at least a few weeks after installing the bricks.
• Before tying the target area, it must be moistened.
• The best time to use the prepared mortar is maximum 2.5 hours.
• In order to homogenize the mortar suitable for strapping, it should be kneaded for at least a few minutes.
• Never use a mortar board for this purpose.
• When tying, you should put the mortar on the tying pen and then insert it between the groove of two bricks.
• Wet wipes should never be used to clean the additions of mortar between the grooves.
• The type of brick and its quality as well as the mortar in doing the best work Brick strapping It plays a very important role, so try to prepare and use high-quality bricks as well as uniform and very fine mortar for building and fastening it.

last word :

As mentioned, the act of strapping plays an important role in brick buildings in order to strengthen and prevent moisture penetration. Also, in order to repair some buildings that are exposed to humidity and weather conditions, they use strapping to make the building strong and durable, and also have a beautiful and new appearance.